Instructions for LH Ovulation Midstream Tests

Instructions for LH Ovulation Midstream Strips

Ovulation Midstream Test Instructions are specific to one brand. They are re-published here as a single example of LH urine ovulation test instructions. These instructions should not be generalized to other brands, but do provide a general rubric for how tests are used.

Ovulation Predictor Kits [1](OPKs) allow you to anticipate when you ovulate. Ovulation tests function by measuring the Luteinizing Hormone (LH) content and quantity in your urine. LH is the hormone responsible for triggering the release of the egg from the ovarian follicle. Therefore, when you are able to detect the increase of LH (called the LH surge) with an OPK, then you know that the ovum is about to be released. This separation of ovum from follicle is, by definition, ovulation itself.

The surge in luteinizing hormone that is detectable by an lh test typically anticipates ovulation by about a full day or two. That's why ovulation tests [1] are perfect for predicting fertility: Once you receive a positive result, you can time intercourse so the sperm will be waiting and ready for the egg as the descends down the fallopian tube to the uterus. It will be in the lower portion of the fallopian tube or in the uterus where fertilization takes place. In short, once you receive a positive result, it is recommended to have intercourse that day, the following day, and the day after. Note that once ovulation takes place, and the egg separates from the follicle, the egg can only survive for about a day. This is why timing sex is central to increasing your odds of becoming pregnant during a particular cycle.

Your Cycle Length

Day to Begin Testing
21 days Day 5
22 days Day 6
23 days Day 7
24 days Day 8
25 days Day 9
26 days Day 10
27 days Day 11
28 days Day 12
29 days Day 13
30 days Day 14
31 days Day 15
32 days Day 16
33 days Day 17
34 days Day 18
35 days Day 19
36 days Day 20
37 days Day 21
38 days Day 22
39 days Day 23

1) Determine When To Begin Testing for Ovulation

Determine the length of your menstrual cycle over the last few months.

Use the chart to work out the day you should begin testing. The day you begin testing is listed opposite the number of days in your normal cycle.

2) Ovulation Midstream Test Procedure

1. Select a well-lit room with a clean surface for performing and/or interpreting the ovulation midstream test.

NOTE: Use the ovulation midstream test once a day, at about the same time - between 10:00 A.M. and 8:00 P.M. Do not use first morning samples as LH is synthesized in your body early in the morning. It will not show up in urine until later in the day.

The best time to test is between 10am and 8pm. Be sure to test at the same time each day. Also, reduce your liquid intake around 2 hours before testing urine as a diluted liquid sample can prevent LH detection.

2. Remove the test stick from its foil pouch by tearing at the notch and take the cap off the test stick.

3. To perform the test, turn the test stick so that the absorbent tip is located down and away from you (do not allow urine to make contact with the test window). With the absorbent tip pointing in a downward direction and the test window facing away from your urine stream, hold the absorbent tip in your stream of urine. Hold it for at least six seconds so that adequate urine is absorbed.

4. Re-seal the test with the cap and place on a flat try surface, result windows facing up. You should see a rose-pink color moving across the viewing window as the test begins to work.

Pregnancy Tests

5. In 3 to 5 minutes, a rose-pink color band (control band) will appear in the window to show that the test is complete. Interpret the results as shown below. For best results, tests should be interpreted at 5 minutes. Do not read test results after the initial 5 minute interval.

Ovulation OPK OPKs Testing

Interpretation of Results
Within three to five minutes, two color bands will appear. Interpret tests results at 5 minutes. To determine your result, compare the color intensity, i.e. shade of color, lightness or darkness of color, of the test band (T) to the control band (C). In determining a positive or negative result, it is important to compare the color intensity for this will indicate whether or not the LH surge (indicating ovulation) is in progress.

POSITIVE: Positive for the LH Surge: If the test band (T) is of equal or greater intensity (equal or darker) than the control band (C), this is a positive result and a good indication that the LH surge is occurring.

NEGATIVE: Negative for the LH Surge: If the test band (T) is of lesser intensity (lighter) than the control band (C) or the test band cannot be seen, this means the LH level of the sample is at or near its basal (normal) level and that the LH surge is not in progress.

> Pregnancy Test Strips [2]
> Pregnancy Midstream Tests [3]

> Ovulation Test Strips [4]
> Ovulation Midstream Test [5]

Source URL: http://ovulation-calculator.com/testing/instructions.htm